Brentwood Towers 5 and 6

Brentwood Towers 5 and 6 are the next phase of The Amazing Brentwood in Burnaby. It’s Shape’s big master-planned community, built right on the SkyTrain line.

The scale is large. Tower 5 holds 506 homes, and Tower 6 adds another 369 plus affordable units and rentals — hundreds of suites in all.

A high-rise like this means the same floor plan stacked over and over, and every suite needs backing in the same spots: fixtures, cabinets, grab bars, and TVs.

That repetition is where pre-cut pays off. It’s the same cut made hundreds of times, done at the factory instead of on the floor. The crew stops measuring and starts installing. And because EZI BACKR is made in BC, it lands local and on time.

What they ordered

23,000 pieces of 3/4″ Standard EZI BACKR.

Every piece is cut at the factory, so there’s no measuring or cutting on site and no offcuts piling up in the bin. On a repeating floor plan, that saved time adds up fast.

The savings

So far, these towers have saved over $30,000 and over 1,400 hours.

That’s labour the crew didn’t spend cutting, waste that never hit the bin, and margin kept on the job.

Your crew leaves on time.

_{Exact math: 23,000 pieces ÷ 24 × $33.37 = $31,979.58 (3/4″ Standard rate). Hours: 23,000 ÷ 24 × 1.5 = 1,437.5 hours.}

Why EZI BACKR

Less labour. Pre-cut at the factory. The crew installs it directly instead of measuring and cutting on site.

Less waste. Right sizes, every time. Fewer offcuts, less material in the bin.

Better margins. Time saved and waste cut go straight to the bottom line.

Steady supply, on time. Cutting equipment built for volume, so orders land when needed.

Made in BC. Canadian manufacturer, local supply chain.

See how much you can save with our EZI BACKR Savings Calculator